• 7 Posts
  • 97 Comments
Joined 1 year ago
cake
Cake day: June 7th, 2023

help-circle



















  • Good call on a deep clean. I’m sure you’ll figure it out. I think it’s a lot of trial and error for most people at the beginning.

    That piece on the FEP sheet is where it let go from the supports when the build plate lifted. More support will probably fix that.

    I always think about what’s happening when I’m doing supports. The resin gets cured on the FEP then the build plate moves up and pulls that layer off the FEP. The part is being pulled by forces in opposite directions so we need to make sure that the part hanging on to the build plate is sufficiently anchored so it’ll pop off the FEP and not off the build plate.