I looked at the spec sheet and it seems that just taping the cells together like that should provide necessary support for all but the outer sides.
A clamp wouldn’t hurt, but probably give me negligible benefits in the projected lifetime of this pack. I’m not using this very often so the pack will age out before charge wear will be an issue. Say I get 300 charge cycles over 10 years, that would be heavy use for my radio pack.
I would look at fabbing up a box that fits snugly, rather than “clamping” them. That could protect against puncture as well. A 3d print or thin plywood glued together would be fine.
Thanks. Got to make a clamp for the batteries then.
deleted by creator
I looked at the spec sheet and it seems that just taping the cells together like that should provide necessary support for all but the outer sides.
A clamp wouldn’t hurt, but probably give me negligible benefits in the projected lifetime of this pack. I’m not using this very often so the pack will age out before charge wear will be an issue. Say I get 300 charge cycles over 10 years, that would be heavy use for my radio pack.
I would look at fabbing up a box that fits snugly, rather than “clamping” them. That could protect against puncture as well. A 3d print or thin plywood glued together would be fine.
I was looking into that. Good idea.
deleted by creator