Als kruisbericht geplaatst vanaf: https://lemm.ee/post/2786110

A United Boeing 767-300, registration N641UA performing flight UA-702 from Newark,NJ to Houston Intercontinental,TX (USA), landed on Houston’s runway 26L at 10:34L (15:34Z) but touched down hard. The aircraft rolled out without further incident and taxied to the apron. There were no injuries.

Source: https://avherald.com/h?article=50c768a7&opt=0

  • deweydecibel@lemmy.world
    link
    fedilink
    English
    arrow-up
    6
    ·
    edit-2
    1 year ago

    The final contributing factor was the aircraft flying very close to its maximum landing weight. The airplane landed at 196,000 lb and has a maximum landing weight of 198,000 lb, which is considered to have contributed to the damaged caused to the airframe.

    Never heard of “landing weight” before. Is that basically just take-off weight minus the burned fuel it took to reach the destination? Can they potentially burn off more fuel prior to landing to reduce this risk?

    • GlobalMagentaOP
      link
      fedilink
      arrow-up
      6
      ·
      1 year ago

      Correct. It is also used for performance calculations. For example to calculate what Autobreak setting should be used based on the runway length, METAR and landing weight.

      I know Airbus aircraft calculate the “EFOB” (End Fuel On Board) in the MCDU. A pilot can calculate the Landing Weight based on the EFOB number by looking at the current weight and calculating based on the EFOB what the landing weight would be.